Product Description
Rated Voltage: 380/480 Voltage AC
50/60 Hertz System
Load Rating : 900 AMPs
Maximum effective load limit : 450 KW
General Enclosure : NEMA III Indoor/Outdoor
Duration of the warranty :10 Year
20 Year Design Life
Device to reduce power consumption is to stabilize voltage and prevent unstable voltage, leading to lower electrical consumption and prolong life.Capacity controlled electric current is used to balance, which helps improve the efficient operation of electrical appliances and avoid consumption of electricity does not work.
HOW DOES THE ELECTRIC SAVER WORK?
When a motor in your home starts, it asks your utility company's transformer for power. The demand of electricity from your motor runs through the wiring in your home, to the panel box, traveling to your meter, finally reaching its destination of the transformer and back down to your home again. Throughout this process, the lines/wiring heats up and strains the motor and wiring. The heat generated is called watts.
During a normal electrical process, there is lost energy that you are being billed for by your energy company but are not able to use.
Low power factor results when inactive motors are operated at less than full load. This often occurs in cycle processes such as those using circular saws, ball mills, conveyors, compressors, grinders, punch presses, etc. where motors are sized for the heaviest load. Examples of situations where low power factor (from 30% to 50%) occur include a surface grinder performing a light cut, an unloaded air compressor and a circular saw spinning without cutting.
The Electric Saver stores (otherwise lost energy/watts) and releases energy to your motor when needed to function properly. This reduces the amount of heat on the wires and the motors in your home. Reducing this heat will lower your electricity bill and increase the life of your motors in your home. Inductive Motors are in your Refrigerator, Freezer, Washer, Dryer, Ceiling Fans, Air Conditioning Units, etc. If you use the old T-12 Fluorescent Lighting, the ballast is also an inductive load.
Using methods from large industrial complexes, The Electric Saver reclaims wasted energy and recycles electrical energy. It protects against power surges and increases the capacity to your electrical panel by causing it to run cooler. By doing so, this saves you money $$$$$!
"Over 16 Billion Dollars of Electricity is unusable energy, but billable in the U.S." - US Department of Energy