Packing specification of BD181 wear resistant ceramic adhesives:
Two component,5Kg/group(A component: 4Kg, B component: 1Kg),packed in a plastic drum.

performance features of BD181 anti wear high temperature resistant ceramic adhesive:
black daub shape,the temperature resistant is 200℃,with strong initial viscous force
It's consist of modified heat resistant toughening resin and special curing agent,aging resistant(can reach more than 8 years),high temperature resistant,good toughness
Can cure at room temperature,can also heat for curing
During constructing on the ceiling and facade,it doesn't flow and fall off.
When it is used as repair agent,the highest working temperature is 180℃,when it is used as structural bonding,the highest working temperature is 160℃

product usage of BD181 high temperature anti abrasion ceramic special adhesives:
mainly used in the bonding of wear resistant ceramic chip on the ceiling and facade of the equipment. With strong initial adhesion,it won't fall off without using magnet or other support measures during construction,optimizing construction technology and reducing construction cost)

How to use of BD181 high temperature anti corrosive abrasion resistant ceramic adhesive:
1.  Surface treatment:Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,finally clean it by cleaning agent.
2.  Configure adhesive: According to A:B(mass ratio)=4:1,make A and B two component mix uniformly
3.  Using adhesive:Make the configured adhesive be coating on the adherend surface uniformly.
4.  Curing:Full curing for 24 hours at room temperature,heat it up to the temperature of 80℃ and keep this temperature for 2 hours,then do the post curing,can get the higher strength(≥18MPa)
5.  The configured adhesive should be used up within the coating application time limit

performance index:

BD181 wear resistant ceramic special adhesive physical mechanical properties table
color	physical state	density(g/cm3)	compressive strength(kg/cm2) GB/7124-2008	shear strength(kg/cm2) GB/1041-2008	impact strength(J/cm2) GB6328-1999
black	paste/thixotropy	1.48	1101	183	60

BD181 wear resistant ceramic special adhesive curing features table(test condition:temperature:20～25℃,relative humidity:55)
coating time limit(min)	curing time	need curing time before full load operation	working temperature(℃)	the highest temperature resistant(℃)
30～60	room temperature:24h or room temperature:1h+80℃:2h	36h	-60～180	200

Special version:
1.  This parameter is for laboratory conditions,due to the actual working condition is more complex,suggest users do pretest according to actual working condition
2.  When the environment temperature is below  15℃,the curing time will prolong,should take proper heating measure
3.  When the environment temperature is more than 25℃ or the mixing quantity is too large,the curing speed will expedite,should properly shorten the application time of coating after mixing.

Transportation storage of BD181 high temperature anti corrosion wear resistant ceramic adhesives:
1.Sealed storage in the cool and dry place,the warranty period is 1 year.
2.Avoid placing it upside down,knocking against and transporting it as a non-dangerous product during transportation.