Standard Size

Pre-galvanized pipe made by black pipes dipped into zinc pool for galvanized. Zinc coating :60 – 80g /m2

Steel Grade: Q195-Q345, S235JR, S275JR, S355JR, S355J2H, STK400/500. 

Standard: BS1387-1985 , DIN EN10025 ,EN10219, JIS G3444:2004, GB/T3091-2001 ,ASTM A53: GR. A , GR. B, GR. C. 

Surface: hot dipped galvanized ,Pre-galvanized , electro galvanized ,painted, threaded ,beveled ,grooved , engraved .

Packing: Two tags on each bundle, Wrapped in waterproof paper, with several steel strips, 

Test:: Chemical Component Analysis, Mechanical Properties (Ultimate tensile strength, Yield strength, Elongation), Technical Properties (Flattening Test, Bending Test, Blow Test, Impact Test), Exterior Size Inspection, Hydrostatic Test, X-ray Test. Third party inspection:SGS, BV, Lloyds etc.

1. TOLERANCE:

a) On Specified OD + 0.5mm (Ovality 0.5mm)b) The Inside Diameter of ubes shall allow insertion of a guage of 37.7mm dia for a minimum length of 200mm.c) On Wall thickness -10%d) The mass deviation on a single tube shall not exceed -7.5% of the specified mass.

2. ENDS:

Cut cleanly and nominally square with the axis of the tube and free from excessive burrs.

3. PROPERTIES:

a) Chemical (Maximum) C - 0.20%, SI - 0.05%, MN - 1.40%, P - 0.04%, S - 0.045%, AL - Min. 0.02%.b) Mechanical = UTS - 340 to 520 N/mm2, YS - 235 N/mm2 (minimum) & %Elongation on 5.65 S0 - 24% (minimum).

4. FLATTENING TEST WELD AT 90 DEGREES (COLD):

a) For weld : Distance between the platens, measured under load is not greater than 75% of the OD of tube.b) For Material :Distance Between the platens, measured under load is not greater than 60% of the OD of tube.

5. STRAIGHTNESS:

1 in 500 (In 1 meter it should not exceed 3mm).

6. ZINC COATING:

Minimum local coating thickness on the outside surface 40 microns.(GALVANIZING)

7. MARKING:

a) We can emboss mill sign "EN 39 UTP 3 or 4." online at every one meter interval over the length of pipe.b) We can do online stencilling as per customer needs.

8. PACKING:

Hexagonal type.

galvanized scaffolding pipeOutside diameter (mm)	galvanized scaffolding pipeWall thickness (mm)	galvanized scaffolding pipeLength (m)
48.3-48.6	2.0-2.5	0.3-12
48.3-48.6	2.75	0.3-12
48.3-48.6	3.0	0.3-12
48.3-48.6	3.25	0.3-12
48.3-48.6	3.5	0.3-12
48.3-48.6	3.75	0.3-12
48.3-48.6	4.0	0.3-12