ZF Electronics was founded in 2003, headquartered in Shenzhen China, the world's most complete electronic supply chain. ZF electronics has beenOne of the Professional, from prototype to mass production. Our process includes recommending customers to select easy-to-purchase p/n components in the design stage of a new project and purchasing all electronic components, PCB manufacture,, testing, and fast delivery to our customers.

 

as the name suggests,   cannot be seen. Blind Via in PCB is the via that connects the surface layer and the inner layer without penetrating the entire board. In order to increase the space utilization of the PCB circuit layer, the blind via is produced. Blind via is located on the top and bottom surfaces of the printed circuit board and has a certain depth. It is used to connect the surface circuit and the underlying inner circuit and the depth of the hole usually does not exceed a certainBlind via aspect ratio (aperture).

 

how to manufacture blind via PCB?

 

the blind via PCB production method requires special attention to the depth of the drilling (Z-axis) to be just right. If you do not pay attention to it, it will cause difficulties in electroplating in the via, so almost no factory adopts it. You can also put the circuit layer that needs to be connected in advance in the individual circuit layer. theHdi vias are drilled first, and then glued together, but more precise positioning and alignment devices are required.

 

the line width and line spacing of most process equipment: blind via 0.1mm, 0.125mm, 0.15mm.

 

Difference between blind via and plating through hole PCB

 

from the processing point of view, through hole circuit board PCB and blind via hole PCB have different requirements for cutting tools in terms of chip removal ability. the processing ofBlind buried vias  makes it easy for the cutting tool to be buried in iron chips, so better chip removal performance is required.

 

It is better to use spiral flute taps to machine blind holes, instead of straight flutes, it is easy to block chips and cause tool breakage.

 

for drilling and blind hole processing, it is best to use an internally cooled central water outlet drill bit. with the central water outlet effect of the machine tool, the iron filings can be forced off by the coolant pressure, so that the iron filings will not be entangled and blocked, which leads to over-tolerance in machining and breakage of tools.

 

the boring is the same as the drilling, and it is best to use the center outlet.

 

but the above statement is not absolute espeically when you want custom made PCB boards. It mainly depends on the depth-to-diameter ratio of the blind via. If the shallow hole is processed, it can also be used as a general plating through hole PCB processing tool.

 

If you have questions about our blind via PCB production capacity, or the specifications required for your custom project are not listed on this page, please feel free to contact us. We will reply within one workday. We will continue to provide quotation support and design support. Welcome to learn about our production process.

 

Other PCB Fab

 

Related Videos

 

Leave a Message

 

PCB Market

 

Related News

 

FAQs

 

how to Get a Quotation for PCBA (Assembly PCB)?

Please send BOM(Bill of Material/Components) and above mentioned PCB files. It's better if you could supply finished production photos and full requirement detail images.

 

What will need for PCB clone service?

Please send us the printed circuit board concerned,and also the sharp photos of its front side and the back side.