Adopting 'Taian?TAZ5281J/04 drive 6 x 4 special carrier for truck crane with high quality main components and parts being purchased at home and abroad. 4-section hexagonal main boom and 1-section jib. With strong lifting capacity and wide working range Equipped with STEYR engine (according to European standard I1), clutch, CWB big torque transfer shaft and German PAT load moment limiter. With superstructure air conditioner (cool & heat), it makes operator more comfortable when operating. Hydraulic system for both superstructure and chassis adopts new leak-proof joints and pipe lines. Contour dimension figure: 1. The tabulated values are rated lifting capacities of crane on solid ground and in level state. The tabulated working radii are actual radii after load lifting. 2. The values above the bold line are based on crane strength, those below are based on the crane stability. While lifting with boom length of 10.7m, each section must be fully retracted. 3. The tabulated load values include weight of hooks, main hook is 300kg and aux. hook is 100kg. While the jib is in extension state, the rated load capacity lifted by main boom must be reduced by 400kg. 4. When the main hook is at the head of main boom and lifting with jib, the lifting capacities of jib must be reduced by 300kg. When working with head pulley, the rated lifting capacities of each section must be reduced by 300kg, while the max. lifting capacity is 2500kg. 5. Lifting 1200 in front of the crane is not allowed when the fifth outrigger is not in use. With the fifth outrigger extended, lifting operation according to the tabulated values in 3600 range could be fulfilled. 6. If an actual boom length or a working radius is between two values in the table, lifting capacity should be determined by the smaller rated lifting weight according to larger ones of the two values. Max. rated lifting capacity:25 (t) Max. lifting height:30.62 (m) Max. output power:175kw/2200r/min Total weight:27500(kg)