SPECIFICATION:
Coin diameter : 20mm～28mm
Coin thickness : 1.2mm～2.5mm
Voltage : DC12V+20%
Temperature : -15℃～+75℃
INSTALLATION:
1.Remove the factory plastic token from the coin sampling clamp and install the right coin used.
2.Slide the coin clamp backward & insert a right coin into the clamp slot then pinch the coin.
3.Adjust the insert slot opening size by loosening the screw in the back side of front panel to fit your coin’s diameter if necessary that can prevent the bigger invalid coins from inserting.
4.Select the right mode between Normal Open & Normal Close.
Choose the right speed of coin acceptance among 100ms (Slow speed/Long pulse) & 50ms (Medium speed/Medium pulse) & 30ms (Fast speed/Short pulse) by TIMER SWITCH for synchronizing with your software.
5.VR turning for sensitivity of coin acceptance turn clock wise(-) for slack coin selection &anti-clock-wise(+) for strict coin selection against slugs.
6.lines guide of 5 lines with 4 pins connector:
Gray line ---- -- Counter(+/-)-----------------
Red line -- ---- DC+12V ↓
White line ------ Coin signal 8|8|8|8|8|8
Black line ------ GND (Ground) ↑Counter
Gray line --- -- Counter (-/+) --------- - -----