Installation Method For Breaking Ball

1. After pulling on the wire of floating Micro-Switch/Toggle Switch from the concave round hole of braking ball center , gently push the breaking ball to make the teething ring inlay the upper of round hole be fallen off because of the force of electrical wire end , (if has necessity, also may use screwdriver to dismantle this teething ring )then, make this fallen teething ring set on the electric cable to set the position of breaking ball, by to establish position of the water level.
2. Gently pull the breaking ball end pull out the electric cable , until the breaking ball center cover the teething ring again , The breaking ball so long as lightly buckle in the teething ring namely cannot fall in, if this teething ring has the damage or loses, it may use the same diameter bare copper wire to buckle into the electric cable.

Breaking ball enclosed fitting for request
Please directly pull the electric cable line to the control box to avoid using the center joint as far as possible, if has joint, it is absolutely not to plunge the electric cable wire joint in the water.