Introduction:

This is a new pre-treating material for wall surface before pasting the wallpaper. Paint the wallpaper protector on the wall before pasting wallpaper, and then it forms a compact film to prevent the wallpaper from the damage of water, alkaline etc. And it also gives the wallpaper longer life.

Performance:

The protector forms a compact transparent film after dry completely. And the film has these characters such as anti-water, anti-alkaline, climate resistance, softness and low temp, and filling the micro fault of the wall surface.

It's green environmental protection without poisonous gas and doesn't contain volatile organic solvent. No harm to room and body health.

Dry instant: It needs only 2-3 hours to be dry and then you can paste the wallpaper.

Standard: JC/T864-2000

Usage:
1. The surface pre-treat: The surface must be clean, tough, non-dust and without oil and etc.
2. Dilution: Dilute the protector with water and stir thoroughly. The rate keeps: Protector/water=1: 0. 6-1
3. Tools: Inches wool with 9mm hair. Brush from up to down for 1-2 times.
4. Construction area: 12-25m² surface every one litter WD wallpaper protector. The amount is based on the quality of the surface.

Note:
1. Keep it in an open dry place and deep the temp above 5degree cent.
2. Operation temperature: Above 5degree cent.
3. The second painting is permitted only after it is dry completely.
4. Guarantee time: One year for seal