Any individual LED failure will not cause other LEDs in working condition to black out

This is an added advantage over other designs

Direct plug-in replacement for conventional T8 fluorescent tube

With electrical or magnetic ballast and starter

Note that it does not need such ballast, starter to operate and normally its performance should not be affected, if left intact

However, for these models with HB LEDs and higher power factor value

Recommended to bypass the magnetic ballast if there is negative impact on PF value or blinking

Not recommended for fixtures with electronic ballast/starter due to much higher voltage

Internal wiring of such fixture must be reconnected to have the electronic ballast/starter removed

Application areas: suitable for room, hotel, office, supermarket and commercial building