Heating method     The drier is heated by means of steam or elec-tric power, and also heated with hot air di-rectly form rule-& coal-burning hot air furnace.Application scope       Fluidizing drier is also called fiuidization bed. Through continuously improvement over 30 years, it has widely applied in the fields of pharmaceutics, chemicals, foodstuff, processing grain etc. For example, the dehumidification and drying of powder and granular materials such as bulk pharmaceutical, granular patent medicines, preparations, feed, plastic resin etc. The granular diameter shall be withinnthe range from 0.1 to 6 mm and the best from 0.5 to 3 mm. Working Principle         working principle is that the clean & hot air enters into fluidization bed through distributor of valve plate. The wet material fed from feeder will be formed a fluidization state by hot air (jumping within the bed like boiling water),so it is called fiuidizing drier or machine, Because of the wide contact between hot air and materials, their drying time is shorter. The air enters from one end of bed, through "boiling" several minutes, and then comes out automatically from its another end. The drier is also applicable for thermal sensitive materials as a result of very short drying time and lower temperature of maaterial proper.Installation Explanation  1    Fluidizing bed, cyclone separator and cloth bag dust remover should be palced on the flat concrete ground, and no foundation screws needed. The fan with underframe and foundationscrews may be installed in-door or outdoors. The plan can be adjustd slightly in accordance with the practical conditions.    2   No air should leak in air pipe system to be free from the influence on drying efficiency.