Introduction: It is a new applied type building open angle-protecting mesh., it is made up by joint steel bar and pull-joint mesh, the pull-joint mesh form the =90°angle through the joint steel bar, there are round hole on the pull-joint mesh which is parallel with the steel bar. The new applied type can protect and enforce the open angle, avoid the open angle falling off, distortion,crazing.The cost is low, the structure is simple, and can be operate shortcut, the construction is convince. It has the widely practicability.
The angle-protecting mesh is shaped through extend of the hot galvanized plate and stainless steel plate. The two extended wings of the mesh can combine firmly with the compo, it used in the the building and form the smooth,straight,simple angle; and protect the angle from disrupting, hitting,and destroyed. The stock length is 2.4m--3m, or produce according to the customers' request.

I. Width of fabric: max.1600mm
II. Thickness of fabric: 30-400mesh(square holes gauge) - 2800 mesh (special gauge)
III. Crank shaft rotating speed: 72 rpm   
IV. Power of motor: 4 KW Rotating speed of motor: 1420 rpm
V. Total weight: 3200 kgs            
VI. Total measurement: 2930 x 3150 x 1270mm

Scope of weaving: max.1600mm
Scope of mesh: Square holes gauge: mesh 10-100/inch
Special mesh: mesh 40-350/inch
Crank shaft rotating speed: 53 r/m
Power of motor: 4 KW
Total weight: 6155 kgs
Total measurement: 2569 x 3535 x 1849mm