Instruction of headlamp
Applying range
It is widly used in the explosion-proof places of petrolum, chemistry, mine, port, firefighting and so on, or other nighting working and the field sports of exploration, mountaineering, rescue and rush to deal with an emergency, acting as the mobile and emergent lighting.
Parameter
nominal voltage 3.7V
accessorial electrical source power 4×0.06W
working current 80mA
continuous discharging time 45h
average using life≥100000
nominal capacity 4Ah dimension 77*56*81mm
power 1W
working current 320mA
continuous discharging time 13h explosion-proof grade ExibllCT4
charging time 6h cover protection grade IP65
average life ≥100000
IEC international standard, GB3836.1-2000 GB3836.4-2000 state explosion-proof standard
Peformance
1. The shell body applies high intensity PC, has the good performance of anti-aging and anti-strike, the outer is assisted with silicon-rubber which is in good elasticity, because of its good aseismatic performance, it can fall off from the height of above 2 meters without damage.
2. Applying the imported large power, high luminance 1W LED, which belongs to the solid state, so the light efficieny is high, the average using life can reach 100000 hous, free of maintenance for the whole life.
3. Applying over large capacity battery, intelligent CMOS chip control the exporting of stable current, and then It can assure the LED luminance stable, the illumination time can reach 13 hours above, ensuring the illuminating quality.
4. Applying cold lamp-house, low heating quality, small working current, good performance of explosion-proof, it can work safely and reliably in any kind of place where is easy to burn and explode.
5. The nice structure design, excellent matreial of anti- strike and fine appearance disposal, water-proof, dust-proof, good performance of anti-corrosive
6. Small volume, light weight, so the whole weight is no more than 210g, you can wear it on head, carry it in hand or hang on your body to use, portability and agility.
Using
1. Before using, put the connector plug of special charger into the charge hole at the back of the head light to charge. When charging, the indicating light is red, after charging fully, it turns to green.
2. Press the switch for 0.5 seconds continuously, the main power is light; when the main power is light, press the switch for 0.5 seconds continuously, you can cut up the power directly. Press it for above 2 seconds continuously, the main power will twinkle, at this time it can be acted as the signal.
3. When the main power is light, press it again, and then the accessorial power is light; When the accessorial power is light, press the switch, and then you can cut up the power.
4. It has the function of preventing wrong operation, if the time that you press the switch is less than 0.5 second, it will not change the on/off estate.
5. There are many wearing ways of the light, you can carry it in hand, hang it on your waist, hang it and wear it on your head. When you wear it on your head, make the pothook of the head light lock the lock-seater of the safty hemlet is ok
Attention
1. It is forbiden to strike, throw, if you are inadvertent to drop it into water or liquor, you should take it out and clean immediately.
2. You only can use the matched special charger, avoid of damaging the batttery. You must charge in the safty place.
Don’t take down the structure parts and sealing parts, avoiding of affecting the performance. If you are sure to take it down, our company will deal wit