This item includes:
3 PCS Nema 34 Stepper Motor with 1600oz-in holding torque for Dual shaft ,
3 PCS Stepper Driver DQ860MA with 7.8A peak current, 256 Microstep, 24-80VDC;
1 PC Power Supply for 350W,48VDC,
1PC Power Supply for 200W,48VDC,
1 PC Breakout Board
1 PC DB25 Cable
1, Stepper Motor
1, Technical Specifications
Part No.: WT85STH151-3004B
Frame Size: NEMA34
Step Angle: 1.8 degree
Voltage: 5.7V
Current: 3.0A/phase
Resistance: 1.9 Ohm/phase
Inductance: 22 mH/phase
Holding torque: 11.2N.m 1600oz-in
Rotor inertia: 3600g-cm2
Number of wire leads: 4
Weight: 5 kg
Length: 151mm
Note: Nema 34 Stepper Motor with 1600oz-in holding torque on dual shaft, front shaft length is 37mm with 25mm flats length, the rear shaft length is 34mm with 25mm flats length, the diameter for motor shaft is 14mm.
RED A+
GREEN A-
YELLOW B+
BLUE B-
Please tell us if you need Double shaft or single shaft, we can manufacture both for you. If you need Double shaft, please tell us your requirements for length of front and rear shaft, as well as the diameter. So that we can offer you the quite good products, thanks!
2, Stepper Motor Driver
|
DQ860MA
|
|
|
|
DQ860MA is a type of two-phase hybrid stepping motor driver, The drive voltage of which is from 24VDC to 80VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with 57mm to 86mm outside diameter and less than 7.8A phase current. This circuit that it adopts is smiliar to the circuit of servo control which enables the motor run smoothly almost without noise and vibration. Hording torque when DQ860MA run under high speed is also significantly higher than the other two-phase driver, what’s more, the positioning accuracy is also higher. It is widely used in middle and big size numerical control devices such as curving machine, CNC machine, and computer embroider machine, packing machines and so on.
|
3, Power Supply
350W,48VDC
4,Power Supply
200W ,48VDC
5, Breakout Board
Description:
- Built in DB25 male connector.
- DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
- DB25 Input Pin: P10,P11,P12,P13,P15.
- DB25 GND Pin: P18-P25.
- Power supply: +5V DC.
- Built in C-class Optical-coupler.
- High quality with Surface-mount Tech.
We ship worldwide!