* Electronics characteristics:

* Rating: DC 12V, 1A

* Contact resistance: 1kHz measured at small current (1A or less)

* Insulation resistance: a voltage of 500V DC shall be applied for a minute, and between conductors which should not make contact under normal conditions after which measurement shall be made

* Dielectric strength: between conductors which should not make contact under normal conditions 500V AC (50-60Hz) for 1 minute (trip current 2mA)

* Endurance characteristics:

* Solder ability: the terminals shall be dipped into soldering flux and shall be immersed into molten solder of 230±5 degrees for a period 3±0. 5 seconds

* Resistance to soldering heat:

* Solder temperature: 350+/-10

* Immersion depth: 2±0. 5mm

* Immersion time: 3±0. 5 seconds

* By a solder iron to have capacity of 60W

* Cold: the jack shall be stored at a temperature of -40±2 for 96 hours

* It shall be subjected to the controlled recovery conditions for 0. 5 hours after which measurement shall be made

* Dry heat: the jack shall be stored at a temperature of -70±2 for 96 hours

* It shall be subjected to the controlled recovery conditions for 0. 5 hours after which measurement shall be made

* Humidity: the pin jack shall be subject to 90%-95%RH, 40±2 for 96 hours, and shall be conditioned at room ambient conditions for a period of 30 minutes

* Payment Details:

* Payment Terms:

* TT in advanced