Laminating press
Rotor press
Stack press
Stator press
Lamination Press
High Speed Press
Motor stator punching line
The main advantages and characteristics:
- National patent technology of crankshaft and square bearing mechanism,two up and down group of,more than 1000mm long roll oriented guide device,four screw micro-adjustment of shut height,which guarantee high orientation guide precision,bottom position precision and "Zero"general clearance.
- Four hydraulic cylinder lifting device for slide lifting up for convenient inspection,replacement and maintenance.
- Under advanced structure and characteristic,much smaller motor is designde for 25% energy saved compared to competitor's similar model,thus the cost is reduced greatly.
|
Modol |
Units |
GD200 |
GD300 |
GD63 |
GD125 | |
|
Capacity |
KN |
2000 |
3000 |
630 |
1250 | |
|
Stroke of Slide |
MM |
30 |
30 |
30 |
30 | |
|
Limit of capacity |
MM |
3 |
3 |
3 |
3 | |
|
Strokes per minute |
S.P.M |
160-350 |
160-350 |
150-400 |
150-400 | |
|
Die height |
MM |
370-450 |
400-480 |
320-380 |
350-410 | |
|
Min slide lifting height |
MM |
100 |
150 |
80 |
100 | |
|
Bed Area |
MM |
1700×950×200 |
2000×950×200 |
950×600×120 |
1300×650×150 | |
|
Scrap an loading area |
MM |
1450×250 |
1700×350 |
680×120 |
1100×150 | |
|
Slide bottom area |
MM |
1470×700 |
2000×800 |
762×530 |
1315×600 | |
|
T-groove |
X |
MM |
50 |
50 |
32 |
50 |
|
Y |
MM |
45 |
45 |
33 |
45 | |
|
Z |
MM |
28 |
28 |
18 |
28 | |
|
V |
MM |
22 |
22 |
15 |
22 | |
|
Total power |
KM |
22/30 |
30/37 |
11 |
18.5 | |
|
Working air pressure |
(kgf/cm2)/(m3/min) |
5.5-7.5kgf/cm2\0.4m3/min | ||||
|
Hydraulic working pressure |
Mpa |
12.5 |
12 |
13.5 |
15.5 | |
|
Total weight |
±2Ton |
35 |
40 |
12 |
20 | |
Note: Notification will come out if there is some change in parameter.