Features:
A Fitted in the back, the air fluidity around is good. It can provide heat dissipation efficiency in limited space.
B The circulation of refrigerant is free, which can reduce the load of the compressor, conserve energy and extend useful life.
Specifications:
1) Raw material:
A) Rolling welded steel tube: 4.76 ~ 6.35 x 0.71
B) Low carbon steel wire: 1.4 ~ 1.6mm
C) Bracket: steel plate SPCC thickness 0.6~2.0
D) Base mounting plate: SPCC thickness 0.6~2.0
2) Technical standards: can produce according to clients' drawing or samples
3) Performance:
A) Surface with electrophoresis coating to prevent the corrosion
B) Inner cleanness can meet the requirement of R134a and CFC cooling system
C) Can satisfy the cooling capability requirements
Structure:
Flat type of wire on tube condenser used at the back
R134a cooling system tube inside standard:
1) Residual moisture: ≤20mg/m2
2) Residual dusty: ≤30mg/m2
3) Residual mineral oil: ≤7mg/m2
4) Residual chlorine: ≤3mg/m2
5) Sealing density: ≥1.65Mpa
Specification of E-coating:
1) Coating thickness:
A) Thickness of anodic electrophoresis coating ≥12μm
B) Thickness of cathodic electrophoresis coating ≥20μm
2) Hardness of coating ≥2H
3) Impact of coating: 50cm.Kg/cm impact, no crack
4) Adhesion of coating: ≥2 grade
5) Flexibility of coating: around R=3D bend 180 degrees, no crack or no fall
Off
6) Corrosion resistant (salt spray GB2423)
A) Anodic electrophoresis coating ≥24hrs
B) Cathodic electrophoresis coating ≥96hrs