VE-700

 

You can load and setup a damaged vehicle in under 10 minutes and be ready to start the repair. You can stand up while changing fenders, the front or rear bumper, hood and other body components. You have easy access to all of the suspension. You have wide open access to the underside of the engine compartment, as well as the underside of the vehicle. Unlike large frame machines that block most of this area because of their size and design. Most of the repairs are of the light to moderately damaged type.It is a much smaller and faster repair system.

 

Length---3000mm

Width----1900mm

Height-----300mm

Air Supply Required----10T

Total Weight----0.9T

 

The ultimate in versatility

10-ton pulling system with 10 ton hydraulics

Full 180 degree swivel for side, front & rear pulling

Post swivels 90 degrees for extended reach

Multiple position set-ups allow for all kinds of pulls

Secure four point clamping system,more firm.

Includes down-pull attachment

No tie downs or anchor pots needed

Fast, easy one man set-up

Completely mobile, use it in the shop, parking lot, wherever pulls are needed

Includes one foot pump

With four stands.