TUHE-7090 cooling pad Color: Yellow or Green Size:W600*L100or150*H1000to2000 A: The characteristics of the cooling pad: 1. It is made from special paper with honeycomb structure. There are two types of wave heights: 5mm and 7mm, and the corrugation is 45°×45°interweaving. Adopt new-generation polymers and space crosslink technology for high water absorption, high water proof, mildew-resistance and long service life. 2. The evaporation area is bigger than the surface, with cooling efficiency reaching above 80%. 3. This product contains no surface active agents, absorbs water naturally, diffuses at high speed, and last effectiveness. A drop of water is completely diffused within4-5seconds, which exceed the national specification standards. The height of natural water absorption is 60~70mm/5min; 200mm/hou, which is fully up to international industrial standards. 4. It contains no phenol or such chemical substances which are easy to cause skin allergies. It is non-toxic, harmless, green, safe, energy-saving, environmental protection, economical and applicable. B: Cooling Principle of cooling pad: The cooling pad is made from special paper with honeycomb structure, and its operation principle is a physical phenomenon "evaporating the water, absorbing the heat”. That’s to say, acted by the gravity, the water flow up-down to form a water film on the surface of the wave-like fiber paper. When the flowing air goes through the wet cooling pad, the water in the water film will take in the heat and evaporate, taking away large amount of heat, cooling the air to make the inner door air fresher, cooler and wetter. C: The scope of produce: Owe the advantaged cooling pad producing equipment, and every produce line values at 5000,000, so everyday can output 50-300m3 cooling pad, the high effective operation, large producing scope can reduce the cost a lot, we try our best to offer the good quality, low-price cooling pad to customers in the usage of economic and scope advantage. D : Application: 1,Ventilating and cooling; 2,Temperature adjusting; adjust the wetness of the textile factory, commercial and civil building.