Application ranges

TXG low flow rate pump is developed for the facts that normal centrifugal pumps application is limited by the condition of low flow rate and high dead. It has the advantages of simple structure, maintenance convenient, performance stable and the application range is wide, etc. It is efficiency is better than general centrifugal pump. It is for pumping clean or slightly polluted, cold or hot, chemically neutral or aggressive liquid, which mainly applied:

n        Oil Production

Water flood, saltwater disposal, oil well exploitation, transfer, oil pipeline injection, reverse osmosis, and steam generation

n        Terrestrial Heat Natural Gas

Feeding, compressing, filling, storage and carriage, transfer

n        Chemical and Petroleum

Descaling, process injection, spraying, sampling, caustic service, seal flushing, reactor feed, high flow metering, transfer, and waste disposal.
 Pollution Control
Spraying, descaling, steam scrubbing, ultrafiltration, reverse osmosis, and other similar application.
  Pulp and Paper
Rinse, propjet incise, boiler feed, reverse osmosis, pigment metering, spent sulfide liquor, and seal flushing.
 Power System
Boiler feed, superheated steam cooling, condensate return, exhaust, seal flush, and turbine Nox suppression
Coal &Mining
Seal flushing, dust suppression, material dewatering, hydraulic mining, and on line injection.
 Aerospace
Washing, refueling, reactor feeding , rocket fuel priming
 Vehicle Manufacturing
Spraying, painting, and lead finish booth cleaning, deburring plastics, continuous electrical wire vulcanization, and gun drill coolant feed.
 General Industry
Vehicle washing, fuel atomization, material feeding, tanning paste board cleaning, continuous electrical wire vulcanization, and boiler system.
Food and Beverage
Portable cleaning, central cleaning, beverage container washing, boiler feed, high flow metering, spraying, material injection
 Pesticide and Medicine
Medicine feeding, recirculation, filtering, reverse osmosis, media transfer
Operating data
Suction size:40mm
Discharge size:25mm
Capacity range(Q): 0.4 to 6.3m3/h
Heads(H): 15 to 100m
Pressure(P): up to 2.5Mpa
Temperature(t):-40 to +200
Characteristics of structure
It is single stage, horizontal radial split partial emission pumptangent pump. A kind of partial centrifugal pump. The pump has a bracket, single suction open impeller, axial suction and tangent discharge.According to the operating, conditions, it can use packing seal or mechanical seals of any design, with cooling and flushing system. The normal pressure level of suction and discharge is same. The pump rotates CCW seen from driven end.

It uses bearings lubricated grease, which is equipped on the bracket, with flexible coupling can compensate little shaft distance of horizontal, radial, and rotational direction.