Introduction:

SVP20B E1 to Ethernet protocol converter provides 2* E1 interface and 4* Ethernet interfaces, can comprehensively replace simple 10/100BaseT to single E1 network bridge. Apply to carriers providing large bandwidth private line access or government, police, enterprise, etc to construct MAN/WAN network, or used to existing narrow private network upgrade. It can also apply to Intellectual Transportation System, Highway Video Monitoring System, High Fidelity Video Conference System and Security Video Monitoring Signal Transmission. 

 

Main Feature:

 

 E1Loop-back Isolation:  When there is E1 link loop-back, the device can automatically detect and isolate this loop-back E1, and give alarm instruction. The isolation can effectively avoid the whole link blocking caused by Broadcast Storm. After loop-back being straight, E1 can automatically return to service. It is a unique function, which can effectively avoid service break caused by careless loop-back E1 during the project and operation maintenance.
 

Strong Power Supply Adaptation:  The device working voltage range is wide (not less than nominal voltage ±20%), adopting appropriate lighting protection, adapt to power supply in remote rural areas. 

 Interface Surge Protection:  Both E1 and Ethernet RJ45 interface adopt advanced SPD device, can effectively reduce the rate of communication interface breaking caused by power supply fluctuation and lighting induction.
 

 Network Management Function:  The device supports local/remote network management, local/remote terminal alarm function.
 

Embedded Mini Switch:  The device has 4 switching network interfaces, can interconnect and intercommunicate.

 

Technical Parameter:

1. Nominal Speed Rate: 2048Kbps, Tolerance ±50ppm

2. Code Type: HDB₃

3. Interface Impedance and connector: 75Ω/BNC or 120Ω/RJ45.

4 .Digital Interface Electrical Specification: Comply with ITU-TG.703 propose;

5. Jitter Performance: Comply with ITU-TG.823 propose

6. Level: ±2.37V±10% or ±3.00V±10%
 

1. Provide 4* RJ45 electronic interface, support local switching;

2. Comply with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX and 100Base-FX

3. Support VLAN function

4. Support full duplex IEEE802.3X flow control, half duplex back pressure flow control

5. Interface Speed Rate: 10/100Base-Tx, 10M or 100M

6. Support Broadcast Storm Suppression

7. Support RJ45 interface direct connection/cross line auto-adaptation

8. Effective bandwidth is 2M
 

1. Power Secondary Lighting Protection

2. E1, RJ45 Interface SPD Prevent Surge
 

1. Connector: RS-232

2. Connector level: RS-232 level

3. Interface Connector: RJ-45

4. Management Interface Baud Rate: 57600bit/s
 

1. DC Power Supply Voltage: -48VDC, Tolerance Range: -24V~-72V

2. DC Power Supply Voltage: +24VDC, Tolerance Range: +20V~+28V

3. AC Power Supply Voltage: 170V~270V

4. Power Consumption: ≤ 10W
 

1. Environment Temperature: 0~60℃    

2. Relative Humidity: ≤90%(35℃)

3. Atmospheric Pressure : 86-106Kpa
 

210mm*140mm*44.5mm(desktop), can be installed in standard 19” rack.