Product Main

Specifications

Model: PST-IR401
 
INSTALLATION
  1. Installation at the out door,place with pets, air-condition nearby, direct sunshine, heat source and under the rotating objects should be avoided.
  2. Surface of installation should be firm with no vibration.
  3. Installing the detector in the place where intruder pass easily.
 
INSTALLATION STEP
  1. Turn the detector counterclockwise, remove the front cover
  2. Screw the PCB off and remove the PCB.
  3. Drill a wire hole in the rear housing.
  4. Install the rear housing  on the suitable position.
  5. Connect the terminal block.(as follows).
  6.  Put back the front cover.
 
OPERATING INSTRUCTION
 
Function Setting
  1. Relay Jumper: Choose NC or NO to set the state of alarm output. You should choose different alarm output in accordance with host. Short 1&2: N.O. Short 2&3: N.C. (Factory-set)
  2. Pulse Jumper: You can adjust the sensitivity and anti RF nterference by choosing the Pulse Jumper.
Short 1&2: class 1 pulse, the sensitivity is highest, adapt to environment
Short 2&3: class 2 pulse,anti RF interference is high, adapt to the environment with
strong RF interference.
Shut off: class 3 pulse, the sensitivity is lower, and the anti RF interference is highest,
adapt to the environment with exceeding RF interference.
  1. LED Jumper: Control LED indicator, without effect of detector normal work.
Short 1&2: set LED ON
Short 2&3: set LED OFF
  1. LED can be shut off for concealment of the detector after Test.
 
Product testing
Turning on power and LED indicator on, the detector comes into state of self-check, it takes about 60s, after that it is in the state of normal work. Conner should walk parallel with the wall installed detector in the testing area. LED lighting means the detector is in the state of alarm.
 
NOTICE
1. Please install and use the detector according to this manual, don't touch the surface of sensor for avoiding affecting the sensitivity of the detector. Please shut off power and then clean the sensor by soft cloth with little alcohol if cleaning needed.
2. The product can reduce accident but may not perform as expected. The user is advised to take all necessary precautions for his/her safety and protection of his/her property.
3. In order to ensure it can work normally, the power should be kept to supply and get on walking test periodically, once a week is better.