Usage and feature:

ZSJ vibrating screen are widely used in metallurgy industry to achieve classification of cold sinter ore whose temperature is under 150 centigrade. According to the working place, the motors can be installed in the left side or right side. According to the different installation place of the motors and exciters, cold mine vibrating screen have two types: one is upper vibrating, two is bottom vibrating. We can design and manufacture various kinds of ZSJ vibrating screens as customer’s request.

Working principle and structure feature:

The ZSJ series articulatory cold mine vibrating screen consists of several sieves. Vibrating in the different sections. According to the different materials, you can properly adjust the exciters’ direction angle of every sieve and sieve surface to achieve the best effective sieving. This screen use two motors to make the exciters rotate reversely, which makes the screen body move along straight line.

Usage and maintenance:

a.Should prevent to start with materials on the machine and clean sundries around vibrating machine before starting.

b.Should stop running to check if operate unbalanced or un-normal sound during working.

c.Regularly check the fastness of all bolts of connecting parts, tighten immediately if bolts become flexible.

d.User should maintain and serve the vibrating motor according to the vibrating motor manual(The grease of the vibrating motor is added generally once every three months. The exciting machine should add grease once a month, a small repair for 6 months, and a major repair for one year)

e.Should clean spring regularly.

Installation and test:

a. Check the concrete foundation, bolts and steer plate according to installation chart before installation. The allowable error is within3mm.

b. The series must install on sequence from the bottom to the up, every steps must be adjusted to the primary status before the install of nest steps.

c. Should adjust the mesh to the appropriate place after vibrating screen installation. Both first and second damping spring should keep vertical status. The axes of the vibrating motor should be lower 3-5mm than that of exciting machine. Weld the motor bracket ,spring seat and steel plate.

d. Make sure the spinning directions of two vibrating motors are reverse.

e. The screen can run for 4-6hours under no-load state inquiring the operating balance of the screen body, without swing and un-normal sound. Check the fastness of the screen boards and exciter machine.

f. The temperature of the shaft should not be over 75 centigrade.