Motion Detector Model: PST-IR202

 

PRODUCT INTRODUCTION

The product is wireless passive infrared detector with high stability. It has adopted advanced technology in signal processing and provided superhigh detection ability and anti error alarm. The detector will detect movement of human automatically when intruder pass through the detected area, and it will send out alarm signal to alarm host if there is movement. The product is suitable for the safety of residential house, villas, factories, markets, warehouses, office building etc.

 

INSTALLATION

Installation at the out door,place with pets, air-condition nearby, direct sunshine, heat source and under the rotating objects should be avoided;

Surface of installation should be firm with no vibration;

Installing the detector in the place where intruder pass easily;

Fixing bracket on the wall by screw;

Hang the detector, it will work normally after turning on the power switch;

 

OPERATING INSTRUCTION Function Setting

1. Delay Jumper: used to set alarm delay time.When set to Test Mode(5 seconds), it will be triggered every 5 seconds when it has been triggered, while set to Work Mode

(5minutes), it will be triggered every 5 minutes when it has been triggered. Short 1&2: delay 5s (test mode) Short 2&3: delay5 minutes (work mode)

2. Code Jumper: used to set address code and zone code with alarm host. A0 A7 is address code, which should correspond with alarm host. (No need for 1527 code IC ) D0 D3 is data code for setting defence zone.

3. LED Jumper: for setting LED ON or OFF without effect of the detector work. Short 1&2: set LED ON Short 2&2: set LED OFF LED can be shut for concealment of the detector after test.