Electromagnetic stirrer (EMS) for slab caster

EM BRAKE: EMBR and FC Mould M-EMS: EMS can be installed inside or outside the mould. S-EMS: there are three modes: behind the rollers; inserting the rollers; roller type. M-EMS for slab Two coils shall be installed along width direct between meniscus and side hole of outlet. Fed by triphase power, it will produce traveling wave field. It is mainly used for medium and thick slab with low casting speed S-EMS for slab * EMS behind the rollers EMS is installed behind the rollers, in one side or each side. It needs little change of caster and installation is simple. It can be moved promptly when breakouts happen. Stirring freq: 0.5 ~ 5Hz. * EMS inserting the rollers Two coils are installed in each side of the curve. The head of EMS is small to insert between rollers and be near to slab. Stirring effect is good for its high efficiency and low energy consumption. Stirring freq: 6~ 20Hz. * EMS of roller type EMS shall be made with the same size of the roller, and placed of rollers, installed in each side of the curve. These two couple stirring rollers are of CrNi heat-proof stainless steel. It is simple to install EMS without limit of caster size. Stirring freq is 2 ~ 5Hz. About Inquiry To help you get the best EMS for your application, we should have the following information: 1. About Continuous Casting Machine (CCM): Model, radius, number of stands, distance between strands and casting velocity; 2. About steel: Kinds and section; 3. About copper tube: Length and thickness of wall.