This tester is an integrated tester for plug. It is used to test the continuity, polarity, insulation, high-volt, leakage current of power plug. It meets the requirements of many international standards such as BIS, UL, CSA, VDE, BSI, DIN, CCC, IEC, etc. It is a totally automatic testing machine makes your operation more convenient and simple.

Features:
* All of the test subjects will be done automatically.
* The inner/outer high-volt output value and persistence period can be adjusted separately.
* Test speed very quick, all test subjects will be achieved less than 2 seconds.
* The PLC control system comes from Mitsubishi, Made In Japan.
* The relay comes from Schneider, Made In French
* If the specimen is incompetent, there is a alarm by buzzer and light.
* If the specimen is incompetent, this machine will stop at once and show you which subject is incompetent. Until you push the emergency button it will restart a new test. And a switch with key can be made to order to replace the high-volt starting button, it is very useful, because when a alarm happen, the operators can not restart this machine, only after managers have checked over and restart it by the key the machine will work again.
* When test over, the specimen will be pushed out automatically, and a "T" or other characters could be marked on it (English characters only).

Technical parameter:
Polarity test: Test E, L, N wires in sequence
Insulation test high-volt: DC 500V +- 10%
Insulation resistance: 2, 7, 20, 50, 100MΩ (can be made to order)
Inner high-volt: 0~5KV +-5% (adjustable)
Outer high-volt: 0~5KV +-5% (adjustable)
Leakage current: 0.5, 1, 3, 5, 10mA (can be made to order)
Rated power: 500VA
Cylinder power: Compressed air with 0.4 to 0.6Mpa
Dimensions: 675mm W, 480mm D, 520mm H
Power source: AC 220V +-10%, 50Hz
Weight: 35 kg, approximate

NOTICE:
1. Inner high-volt is applied between L, N, E wires, and the outer high-volt is applied between L, N, E wires and jacket.
2. Both 3-wire and 2-wire power plug can be tested by this machine.