Type SAP is researched and developed on the basis of type SA and absorbed the advanced technology of domestic and foreign similar products

1. Performance range: Capacity: 72--9900 m3/h
Head: 6.8_104m
All the data of pumps can be changed according to requirements of clients.

2. Construction: The pump is horizontally installed. The inlet and outlet are under the split surface and in the perpendicular direction with pump central shaft-line, during the course during the course of installation, you needn't to remove the motor and the pipes.
Type SLA is vertically installed the inlet and outlet at a same center line and the case and cover are in the perpendicular direction.
Bearing: Both end of the pump are rolling bearings (type 24SA_18, 16SA_90 could use the sleeve bearings)to support the rotor, the lubrication oil is dilute oil or grease.
Materials of tolerance: The material s of tolerance is cast iron or it can be changed into cast steel and bronze, but it should be signed in the order.

3. Description (example):
10SA (SAP\SAM\SAF\SLA)--6A
10_the number obtained from the inlet dia. Divided by 25(the inlet dia. Is 250mm)
SA_single stage double suction centrifugal clean water pump
SAP_changed from type SA
SAM_abrasive single stage double suction centrifugal pump
SAF_anti-corrosive single stage double suction centrifugal pump
SLA_vertical single stage double suction centrifugal pump
6_the number obtained from the specific speed divided by 25
A_the impeller first cut

 

If you have any special requirement, please contact us without hesitation.