Product Main

Specifications

UST116R-S
100-1600m 16CH Active Video Receiver Hub
Brightness Sharpness COMBO (BSCTM) Tool Free Control
Femal BNC, Screw Terminal Block Connector
Transient, Lightning Protection
19“ 1U Mounting Rack, 12VDC/24VAC Supply, Power Path

UST116R
100-1600m 16Ch Active Video Receiver Hub
Code Switches Gain/EQ ADJ, Simple Installation
Femal BNC, Screw Terminal Block Connector
Transient, Lightning Protection
19" 1U Mountingl Rack, 110/220VAC Power (Fuse, Power Switch

UST116R-F
100-1600m 16CH 1-2 Active Video Splitting Receiver Hub
Brightness Sharpness COMBO (BSCTM) Tool Free Control
Femal BNC, Screw Terminal Block Connector and RJ45 Jack
Transient Surge, Lightning Protection
19" 1U Metal Housing, AC Power Supply (Fuse, Power Switch)

UST116R-2F
100-1600m 16CH 1-2 Active Video Splitting Receiver Hub
Brightness Sharpness COMBO (BSCTM) Tool Free Control
Femal BNC, Screw Terminal Block Connector
Transient, Lightning Protection
19“ 1U Mounting Rack, 110/220VAC Power (Fuse, Power Switch)
UST116R-R
100-1600m 16CH Active CAT5 Video Receiver Hub
Brightness Sharpness COMBO (BSCTM) Tool Free Control
Femal BNC, Compact RJ45 Jack
Transient, Lightning Protection, Grounding Connector
19“ 1U Mounting Rack, 12VDC Power and Power Loop Out
UST132R-R
100-1600m 32CH Active CAT5 Video Receiver Hub
Brightness Sharpness COMBO (BSCTM) Tool Free Control
Femal BNC, Compact RJ45 Jack
Transient, Lightning Protection, Grounding Connector
19“ 1U Mounting Rack, 12VDC Power and Power Loop Out
 Introduction
UST116R,UST116R-R, UST116R-S, UST116R-F and UST116R-2F, these five 16 Channel CAT5 Video Receiver/Hubs are active (amplified) pair equipment that allows the extension of real-time monochrome or color video on up to 4000ft (with Image figure enhanced function), using Category-5 Unshielded Twisted-Pair (UTP) CAT5 networking wire. Composite Video Broadcasting Base band (composite-CVBS/AV, PAL/NTSC/SECAM) signals of any video type are supported. UST132R-R is an industry first compact 32Channel CAT5 Video Receiver/Hub

Technical Specifications
  • Video Frequency Response:
    DC to 6 MHz
  • DC Coupled Amplifier Mode
    100V/us transient responding
  • Differential Gain: 0.5%
  • Differential Phase: 0.3°
  • Distance Switch 4-Position Adjustable for each channel.(UST116R)
  • One potentiometer for Brightness & Sharpness ADJ. (UST116R-F)
  • Common-mode/Differential-mode Rejection:
    15KHz to 5 MHz, 65 dB typical.
  • Channels Cross Talk: -68dB.
  • Loop Return Loss: over 15dB
  • Figure Enhanced Output:
    4.43MHz extra emphasis
  • Line Impedance:
    Coax, female BNC 75 ohms, CAT5 line, Terminal Block 100 ohms.
  • Wire Type: Network Wiring One Unshielded Twisted Pair 24-16 AWG (0.5-1.31mm).
    Category Type Cat 5 or better. Impedance 100±20 ohms.
  • DC Loop Resistance 52ohms per 1,000 ft (18 ohms per 100m).
  • Differential Capacitance 19pF/ft max (62pF/m max).
  • LED Indicator: Power On Red Indicator LED Light.
  • Power Supply: 110/220V±20 /50~60Hz
  • Power ON/OFF Switch with 1A Fuse

Environmental
Temperature -20°C to +65°C.
Humidity (non-condensing) 0 to 95%.
Transient Immunity
6,000 V 1.2µS x 50 µS per ANSI/IEEE 587 C62.41 B3.
3,000 V 8µS x 20 µS when 3 ground screw terminals are bonded to earth-ground.
Equipment Installment
1: Put the video signals you need in the VIDEO IN/OUT of CAT5 Video Transceiver.
2: Put a twisted-pair in the VIDEO A, B screw terminals of CAT5 Video Transmitter and Receiver respectively.
3: Connect with the mains following instructions shown in the system configuration diagram or sketch map, make sure AC power line voltage range is in 220V±20/50~60Hz.
4: Set the position of ADJ correctly according to the distance table in Transceiver.
5: 3 ‘GND’ screw terminals are bonded to earth-ground.
6: After the five steps, the 16 VIDEO Outputs of 16 Channel CAT5 Video Receiver/Hub is ready to work.
Check after Connection
1. Power On Red Indicator LED Light.
2. Make sure that UTP wire and coaxial cable is correctly and firmly connected.
3. Make sure the ‘GND’ screw terminals are firmly connected to earth-ground.
Mechanical
Dimensions: 19” 1U
Material: Metal housing case, Mounting Rack

Maintenance & Quality Guarantee
3 Year Warranty