smokehouse YX series allows to make automatically heat processing of butcher products such as drying, cooking , smoking and baking. without any additional operations
- It is possible to use cold smoke technology in a smoke chamber model equipped with chilling(opiton)
- it is made of stainless steel designated for usage in the food industry, the inner and outside sheet steel are made of sus304.
- the reinforced panels (thickness 80 mm) are insulated by the mineral wool.
- the whole construction of chambers, the used material included, provides their long life, perfect temperature insulation, operation reliability and energy savings
- the stainless steel floor with reinforcing against breaking through, antislide surface.
- the switch-board and the smoke generator are also manufactured of SUS 304 stainless steel and the standard position of them are on the left or the right side. In case of a special requirement, it is possible to place the switch-board outside the chamber (on a wall e.g.) and the smoke generator behind the chamber
- the air circulating system provides uniform air stream, temperature distribution and high-quality of drying, smoking and cooking in every place inside the chamber
- the chamber is equipped by two-speed fan, which provides the change of the air speed according to the program step, the fan is placed above the each smoking trolley
- the smoke chamber is equipped by a system of sensors, which measure temperature and relative humidity in the chamber. It is also supplied with the core temperature sensor and supports the “Delta-T“ method.
- the system of air-operated flaps control air input and output in the chamber and also the balance of pressure in the chamber and the surroundings
- the smoke chamber is fit with the system of automatic washing
Wooden-chip smoke generator (standard finish)
- wooden chips generator is provided as the standard smoke producer
- pressure relief generator creates smoke by smouldering of wooden-chips of hard wood
- is controlled by PLC and touch screen.
- is equipped with the system of sensors, which check the smoke temperature
- it is fit with the system of air-operated valves, which regulate the supplied quantity of air
Automatic heat treatment process
- is controlled by the PLC and touch screen, which allows to create 100 programs, 10 steps each
- Customer can make its own programs suitable to his conditions. Ten step permit to build the program so well, that the production process runs in the optimal time with the minimum weight loss.
- Control and programming of the control unit is very simple and allows to change temporarily the running program (e.g. to change the time of drying, etc.). This change is only temporary and is not saved to the memory.
- is equipped by the electric appliances with high reliability and long life.