General Information:

This series of Water-cooled & Portable Generator DC hipot Test Sets adopted " low-voltage shield law" principle , used to test dc voltage and dc leakage current of water-cooled generator, completely overcome the problem that bottom of the water difficult to dry, easy to cause arcing and other problems within the coil. The device is light , sample wiring, and easy to read , output polarization compensation voltage directly by the case.

Features:

1. The electronic controlled equipment , easy to operate;

2. The date of voltage and current are in the panel, reading without conversion;

3. It can be timed and prompts in one minute, according to test procedures;

4. Not only overvoltage and overcurrent protection inside the device, but also attached the zinc oxide overvoltage protection outside to ensure safety of the generator ;

5. Each piece is equipped with special shockproof aluminum boxes, easy to move;

6. The device uses portable, combinat by the chassis, change frequency, times the pressure tube, four boxes and other accessories;

7. Portable structures, especially suitable for field trials;

technical parameters:

1. High output voltage: dc 0 ~ 60/80kv , continuously adjustable;

2. Rated power: 5kw ~ 16kw;

3. Output voltage measurement: analog / digital dual display ± 2. 0% (full scale);

4. Leakage current measurement: analog μ a table ± 2. 0% (full scale);

5. Protection: equipped with high and low over-voltage current protection circuit. Overvoltage protection using dial settings, at a glance. Specifically attached with zinc oxide over-voltage protection outside to ensure the safety of the generator;

6. High output rated current: 80ma ~ 200ma;

7. Voltage stability: random fluctuations, supply voltage change ± 10%, less than 2%;

8. The total output current measurement: the number display ma ± 1. 0% (full scale);

9. Department of water polarization potential compensation: compensation voltage ± 2. 5v. Step before the adjustment panel on " fill compensation zero potentiometer " so that the table refers to zero μ a;

10. One minute timer button: automatically time , in case up to test voltage;

11. The timer buzzer alarm at 50-1 seconds, suggesting that the time to boost voltage ;

size and weight:

1. Chassis(l× w× h) : 600 × 450 × 275 mm weight: 35kg

2. If variable(phase × high): φ 370 × 210mm weight: 24kg

3. Doubler tube(phase × high): φ 280 × 420mm weight: 10kg

(subject to 60kv/200m )