Program or configure Altera devices from 1.8V, 2.5V, 3.3V to 5V.
Reliable and cost effective download adapter for Altera FPGA and CPLD development.
Supports Active Serial(AS), JTAG and Passive Serial(PS) mode.
Allow users to perform the following functions:
Program CPLD, Serial Configuration Device and Configuration Device for Altera device Configure FPGA for Altera devices
Provides a reliable, fast and low-cost method for in-system programming.
Supports Cyclone, Cyclone II, Stratix, APEX II and APEX 20K, FLEX, MAX II, MAX7000S, MAX7000A, MAX7000B,
MAX9000, MAX9000A,


MAX3000A Serials FPGA or CPLD
Supports EPCSX, EPCX Series Configuration Devices.
Supports Quartus II software Version 4.0 or later.
Supports Quartus II SignalTap® II Logic Analyzer (for logic analysis)
High Programming Speed with USB interface to Host PC.
Uses a 10-pin circuit board connector, which is identical to the Altera USB Blaster download cable.
Downloader is powered by USB port, no external power is required.

Devices Support Details:
FPGA: Cyclone, Stratix, APEX II and APEX 20K, ACEX 1K devices, Mercury devices and FLEX.
CPLD: MAX II, MAX7000S, MAX7000A, MAX7000B, MAX9000, MAX9000A, MAX3000A Serials CPLD
Configuration devices: EPCS1, EPCS4, EPCS16, EPC1, EPC4 Series Configuration Devices.
Package includes the following item:




FCPU-A USB JTAG Downloader for Altera Devices.
4 feet high speed USB cable
10 inch flat cable to connect the target (attached with the downloader)