Two, the use of methods

In 1, the main agent and hardening agent ratio 1: 1 ( volume ratio ) ,when using , totally mixed, coated on the surface, and in a fit of light pressure.

2, the appropriate surface treatment: if the surface has  a grease of oil must be  firstly cleared or be abrasive to remove, plastic or rubber surface must be properly handled.

3, Useing  time : as the dosage amount and temperature dependent, generally at 20 degrees C, 100g can use for 1 hours, the film grease dry for 5 hours.

In three, the reference data:

Loss viscosity when  the temperature of the part after heat distortion,  is between 60 DEG C to 90 DEG C , but  - 10 DEG C in winter will not loss adhesion.