1.floating inflatable rubber Fender

(1). High shock absorption

(2). Impact and fatigue resistance

(3). Can be repaired and reused

(4). Various specific

(5). Depending on customer demand

(6). Marine depend on the ball

2.inside and the adhesive layer was

Three out of plastic, in addition to meeting the requirements above, but also meet 1.requirements:

(1) The membership must be at least 8kN / M

(2) 70 ° C ± 1 ° C * 22 hours of age, the rate of permanent deformation must be less than 30%

(3) with an ozone-static (tensile strength of 20% and exposed to 50 ppm * 40 * C 96 h, there should be no cuts.)

(4) at a temperature of - 40 ° C degrees should not have cracks, at a temperature of 70 degrees C, not taped.

(5) in contact with crude oil, motor oil, diesel oil and other liquid petroleum products can have serious phenomena of inflammation and sticky

4 .. Cotton are

The density of the fabric of spun cotton (95 ± 5) / 10 cm wide, hot tensile cotton rope (280 ± 10) N / root.

5 .. performance

(1) the ball for the original tire pressure, a 24 should be no pressure drop.

(2) with a bullet in the compression ratio of 60% after the release of pressure, its diameter is 5 minutes included in the original diameter of more than 97%

(3) The ball compression ratio of 60% when the forces of reaction and to absorb the amount must not be less than that indicated in the table.