Laser Tube Laser Power: 15-150W
- ● Water cooling: using purified water; 2 to 5 liter/minute; water temperature: 10℃-40℃.
- ● The operating environment: temperature 2-40℃, humidity 10-60%.
- ● The working current: test current is 29mA. Maximum working current is 29mA. The running current must be kept below 27mA. The life span can reach 10,000 hours if the current is kept below 25mA. The ammeter indicating current must be connected to the negative electrode of the laser tube.
- ● When it is working under over-high current for long term, the negative pole will appear light yellow, and the life span will be reduced rapidly.
- ● To protect dust from going into the insulation sheath, please wrap it with plastic film.
- ● Cutting function.
- ● Engraving function: Very good, when the working current is 4mA and the tube is in the state of preionization, the laser can be used for high-frequency impulse engraving.
- Do not clean the exterior surface of the output widow mirror with tools such as tampon; otherwise the output power will be seriously affected. The followings are the designated methods to clean up pollution in the exterior surface of window mirror:
- 1) When the mirror is polluted, do not turn on the laser.
- 2) Blow the mirror surface sideway with air blower.
- 3) Spray the pure alcohol on the mirror surface with sprayer.
- 4) Turn on the laser after the alcohol gets fully volatilized.
- 5) If the methods above don't work effectively, it is necessary to ask for the professional to use tampon with alcohol to clean the mirror surface from middle to edge. The best solution is to prevent the window from being polluted.
- Attention: it is forbidden to clean the mirror with acetone.
- The screw in the front and back ends of the laser tube is not allowed to be moved, otherwise the out power will be declined and even the tube may be scrapped.
- Put the acryl 300mm far away from output mirror, when testing the laser spot.
- The Laser Tube is invisible light. Please wear protective glasses when debugging the laser. The positive pole is in high voltage. Pay attention to the security marks.