Electrostatic powder coating gun system:

1.Electrostatic powder gun spray system manufactured in the country modeled on Wagner electrostatic powder gun spray system of Germany

2. The system modeled on Gema electrostatic gun spray system and elevator system of Switzerland

3. The system modeled on KCI electrostatic gun spray system and elevator system of Korea.

4. The system modeled on Nordson electrostatic gun spray system and elevator system of USA.

Regulations for application safety of electrostatic powder hand spray:

In order to be away from danger, following safety standard shall be complied with while operating.

1. Reliable ground connection shall be provided for work-piece and other objects that conduct electricity in a range of 5 meters in the spray working zone.

2. The floor for spray working zone shall be conductible.

3. Attach one side of the ground line to rotary chain column or

other equipment that has a ground line, grounding resistance <=4ohm.

4. Wire and powder pipelines shall be properly arrange so that not be damaged due to exterior forces.

5. The power switch shall not be not until the booth recycling system

opens, and it shall be off while the booth is being repaired due to some failure, to prevent static electricity does harms on workers.

6. Each conducting object shall be checked with it grounding status every week.

7. Shut off the power of control unit while cleaning or replacing nozzles.

8. Clean the powder on the hooks period regularly, or rate of powder

absorption on work-piece will be affected, moreover blocks the grounding of the work-piece and the high voltage static electricity not conducted in time will consequently hurt the workers.

9. The attitude of the spray gun shall be adjusted in advance as for

complex work-piece. The distance between the gun and the work-piece is at best 20cm, not any further or closer.