Introduction of AAC production line

1. Storing and supplying of raw materials of AAC blocks:

All raw materials are carried into factory by trucks, such as Fly ash, sand, lime and cement and so on are gathered in specified raw materials field waiting for use. Sack of cement and bulk cements are stored in cement warehouse. Chemicals and aluminium powder are separately kept in chemical bin. When used, these raw materials are carried into workshop respectively.

2. Processing of raw materials:

Fly ash, sand, lime and cement are sent into ball mills by vibration feeders and screw conveyor. Then fine powders of fly ash, sand, lime and cement are pumped into slurry tank.

Quick lime is sent by vibrating feeder and screw conveyor into jaw crusher to smash. Smashed lime is sent into lime silo by bucket elevator and then is transported into ball mill by screw conveyor. Fined materials are sent into proportion bin by screw conveyor and bucket elevator.

3. Aerated block ingredients, pouring and casting

Fly ash (or sand or stone powder) and waste slurry are measured in measuring tank. After the measuring and mould in their place, slurry stirring begins. Slurry temperature should reach about 40° C.

4. Aerated block's procuring and cutting

The features of AAC blocks

Compared with traditional clay brick, AAC block is the most economical and eco-friendly building material. As a kind of new building material, AAC block will be the ideal choice for all kinds of modern building.

 

(1) With light

(2) Keeping warm

(3) Fire protection

(4) Sound insulation

(5) Less errors

(6) Strength high

(7) Green initiative

(8) Low cost

 

Annual capacity

We are specialized supplier of complete set of AAC plant with 50000m3, 100000m3, 150000m3, 200000m3, 300000m3, capacity annually, including plant design, equipments installation, technical instruction, personal training, etc., and also we design and manufacture as per clients' requirement.

 

Raw materials: Fly ash, sand, cement, gypsum, aluminum powder

 

Fly ash style aerated block raw material proportion

Parameter Name Parameter Value

Flash 65-70%

Cement 6-15%

Lime 18-25%

Gypsum 3-5%

Aluminum powder paste 8

Water & material rate 0.60-0.65

Casting temperature 36-40° C

Aluminum mixing time 30-40s

 

Sand style aerated block raw material proportion

Parameter Name Parameter Value

Sand 55-65%

Cement 10-20

Lime 20-30%

Gypsum 2-3%

Aluminum powder paste 8

Water & material rate 0.65-0.75

Casting temperature 35-38° C

Aluminum mixing time 30-40s