---

Disconnect  the plug connectors which are already attached to the IAT and attach
the plug connectors of the NitroData module to the relevant connector of the
IAT. The NitroData is now ready to use. 
or behind the dashboard/front headlight on Ducati bikes your user manual for the
location or contact your reseller or DM (please either check your user manual for
the location). 
As some motorcycles run richer and others are leaner, we suggest that you start
by using the NitroData with the dial set to minimum and gradually increase the 
dial to a higher until you find the setting which is best for your bike A slightly
modified engine (sport exhaust,air filter etc.)will generally have a better
performance  with the dial set around midle if the bike has an aftermarket
exhaust system fitted. A setting between midle and midle more can be used
when the catalytic converter has been removed.The original standard
performance is to be found at minimum setting on control unit. 
If the bike running richer then the setting will probably need to be set between
litle then minimum. You will feel from the performance  of the motorcycle when
the engine is running smoothly and it is not  necessary to run a Dyno test. Please
avoid falling into the trap of thinking the higher the maximum the better the
performance as  it will vary depending on the bike. If it appears that you are
losing the torque when you hit high speeds this most probably   means that you
have set  the NitroData number too high and need to try a lower setting. 
This is another  reason why it’s better to start with a low setting and to gradually
turn the dial to a maxmimum setting