If the potting silicone material is a little thick, then the curing time will be a little longer.

potting silicone material guidelines:

1, Pls put part A and part B in separate container and stir evenly before mixing the two part together.

2, Mixing Ratio: part A: part B = 1:1

3, Deaeration the mixture in vacuum pump under 0.08 MPa for 3-5 minutes. Then the mixture could be used for pouring.

4, Pls note that the thickness of the silicone affects the curing time. The temperature also affects the curing time. When in lower temperature, we suggest customers appropriately heat the mixture to accelerate vulcanization. With temperature of 80~100° C, the silicone will cure in 15 minutes; while in 25° C room temperature, the silicone will cure around 8 hours.

 

potting silicone material Notes:
1. The following material may hinder the curing of HY 9055, So pls use after the test. When necessary, pls clean the application areas.

L Organotin compound or Condensation silicone with organotin

l Sulphur, sulfide and sulfur rubber materials.

L Amine compounds as well as contains the amine materials.

L Pewters solder flux

 

2. HY 9055 should be sealed storage. The mixture should be used up disposably to avoid causing waste.

 

3. HY 9055 belongs to non-dangerous goods, but keep away from mouth and eyes.

4. When it gets stratified after a period of storage, Please mix it evenly before using, which does not affect the performance.

PACKAGE
20Kg/pail as a set (Part A 10Kg + Part B 10Kg)