Compact structure!SGP450*500 Roller Crusher
Roller Crusher Structure and Working Principle
1. Our roller crusher is mainly composed of roller, roller support bearings, compaction device, adjustment device and drive unit etc.
2. Adjustment of discharge size: A wedge-shaped adjustment device that has an adjusting bolt on the top is installed between two rollers. When the wedge is being pulled upward by the bolt, the movable roller will be thrown off from the fixed roller by the wedge. The gap between two rollers will be larger, so that the discharge size will be larger. When the wedge is pulled downward, the movable roller will be compressed by the pressure spring, resulting in smaller gap between two rollers. The discharge size can also be adjusted by the gasket between two rollers. When increasing the number of gasket, the gap between the rollers will be larger. And the gap will be smaller when the gasket is reduced.
3. The drive unit consists of two motors, which drive groove roller through V-belt to make the roller rotate in the opposite direction.
4. After the material enters the feed port, it passes through roller, and then is compacted, crushed, and discharged from the lower side of rack.
5. For the sake of safety, the driving unit should be equipped with safety cover according to the actual situation.
1. Our roller crusher is mainly composed of roller, roller support bearings, compaction device, adjustment device and drive unit etc.
2. Adjustment of discharge size: A wedge-shaped adjustment device that has an adjusting bolt on the top is installed between two rollers. When the wedge is being pulled upward by the bolt, the movable roller will be thrown off from the fixed roller by the wedge. The gap between two rollers will be larger, so that the discharge size will be larger. When the wedge is pulled downward, the movable roller will be compressed by the pressure spring, resulting in smaller gap between two rollers. The discharge size can also be adjusted by the gasket between two rollers. When increasing the number of gasket, the gap between the rollers will be larger. And the gap will be smaller when the gasket is reduced.
3. The drive unit consists of two motors, which drive groove roller through V-belt to make the roller rotate in the opposite direction.
4. After the material enters the feed port, it passes through roller, and then is compacted, crushed, and discharged from the lower side of rack.
5. For the sake of safety, the driving unit should be equipped with safety cover according to the actual situation.
Technical parameters:
|
Drum specification
|
600*500(mm)
|
700*500(mm)
|
|
Productivity(m3/h)
|
10-25
|
25-30
|
|
Fixed roll speed(r/min)
|
268
|
268
|
|
Movable roll speed(r/min)
|
223
|
223
|
|
Roller gap(mm)
|
3-5
|
3-5
|
|
Feeding granularity(mm)
|
<50
|
<50
|
|
Electric motor
|
Y160L-6-11KW
|
Y160L-6-11KW
|
|
11KW*2
|
Y180L-6-15KW
|
|
|
970r/min
|
970r/min
|
|
|
Motor wheel
|
Fixed roll speed138Movable roll speed 120
|
Fixed roll speed138Movable roll speed 120
|
|
Triangle belt
|
B3150*6roots
|
B3150*8roots
|