FEATURES
Dual tracks 1 and 2
Built-in decoder
Standard RS232C interface
Get power from keyboard, no extra power
Stainless steel card guide
ABS plastic cast case
Interface cables included
Auto recognition of IBM or ISO format magnetic DATA record
LED and beep indicate power . read .write. OK.ER
CARTON CONTENTS
603
1. Magnetic stripe encoder, pre-assembled
2. User Manual
3.get power connect cable
4.Test software
5.clean card
STALLATION
Your magnetic stripe encoder is
pre-assembled for easy installation.
603
1. Connect the male DIN 5 of connect cable to the keyboard port for power
2. Connect the female DIN 5 of connect cable to the system keyboard .
3.Connect the female DB9 of YD-6003connector to the connect cable
4. Connect the male DB9 of the connect cable to the communication port .
Notice:
If the pin # 1 of the computer communication port supplies power, the connect cable will not be used to get power from keyboard. Connect the female DB9 of 603 connector to the computer communication port directly.
FUNCTIONAL TEST
603
To functionally test the YD-600 will require the use of a standard credit
card. Place the credit card at one end of the Magnetic Stripe encoder.
Face the magnetic stripe of the credit card toward the arrow of the MSR.
Move (swipe) the card through the encoder.
The credit card information will appear on the monitor. The information
shown on the screen will vary according to the card used. The information
should look similar to the following:
Track 1 %ABCD84045453?
Track 2 ;9437577710640473475?
INTERFACE
603
The YD-600R can interface with any
standard IBM RS232C interface. The
output connector of the YD-600 is
a DB9 female connector.
DB9F Configuration:
1 DCD 6 NON
2 RXD 7 NON
3 TXD 8 NON
4 NON 9 NON
5 Sig. Gnd.
Default Protocol
Baud Rate – 1200 2400 4800 9600 bps at option
Parity – None odd
Initial- 1 1
Data Bits – 8 7
Stop Bits – 1 1
SPECIFICATIONS
Mechanical:
Weight 1250G
Dimensions 217mmL x 59mmW x 63.5mmH
Case ABS plastic
Environmental:
Operating Temperature 0 to +50 deg C
Storage Temperature -20 to +70 deg C
Relative Humidity 90%, non-condensing
Vibration 40 G’s
Shock 40 G’s
Reading and Writing Performance:
Card feed speed 10 to 120 mm/second
Card feed force 0.6oz, typical
Magnetic head life 1,000,000 passes min.
Read error rate < 1 in 1000 passes
Electrical:
Voltage 5VDC +/- 10%
Current 150 ma
LED indicator Green - Good read
or ready to read
Red - Bad read
RECORD DENSITY
Track 1 210bpi max 110 characters
Track 2 75bpi max 38 characters
Track 3 210bpi max 76 characters