B-2000 Infant Incubator
STANDARD COMPOSITION:
●Servo Control Mode: air temp,skin temp;● Instant Parameter Displaying: set temp, air temp ,skin temp,heater power rate;● Audible & Visual Alarms: power failure, sensor failure, higher & lower temp, air& skin temp override,fan failure,system failure;● >37℃ Preset Mode: power failure reset memory, alarm silence, keypad lock, self-test function;● Hood with dual slope: 6 hand-ports; left & right cabinets, top-shelf;● RS-232 Output Connector (Use for network system ).
|
Specifications:
Power Power requirements: AC220v 10%, 50Hz 2% Power input: ≤ 450va Refer to iec60601-1, this equipment belongs to class I, type b. Its operation is continuous. Alarm Power alarm Power failure: Activates if primary power to the incubator Fails or the power wire is accidentally Disconnected from the wall receptacle.
Fan alarm
Fan failure: Activates if fan motor malfunctions. Sensor alarm Air sensor failure: Air sensor malfunction, refer unit to service. Sensor out of position: Activated when sensor is not in correct position to perform calibration or continue operation. Skin sensor disconnected: Activated during skin control mode when skin sensor is disconnected from temperature controller. Skin sensor failure: Activated when skin sensor malfunctions. Deviation alarm high air temperature: Activated if displayed air temperature is 1.5 centigrade above set point Low air temperature: Activated if displayed air temperature 2.5centigrade below set point
Skin temperature: Activated if displayed skin temperature is 1.0 centigrade above set point
Low skin temperature: Activated if displayed skin temperature is 1.0over temperature alarm Over air temperature: Activated when displayed air temperaturewas approach 38centigrade for set temperature ≤ 37centigrade, or approach 40centigrade for set temperature >37centigrade in air mode.
Over skin temperature: Activated when displayed skin temperature was approach 38centigrade for set temperature ≤ 37centigrade, or approach 39centigrade for set temperature >37centigrade in skin mode. System alarm
System failure: Activated if temperature control system malfunctions.
Temperature controlrangeand correlative specifications
Air temperature: 20centigrade ~37centigrade, for set temperature ≤ 37centigrade 37centigrade ~39centigrade, for set temperature >37centigrade Skin temperature: 20centigrade ~37centigrade, for set temperature ≤ 37centigrade 37centigrade~38centigrade, for set temperature >37centigrade Temperature rise time: ≤ 30min Temperature variability: 0.5centigrade Temperature uniformity: ≤ 1 centigrade Skin sensor precision: ≤ 0.3centigrade
Environment requirement
Environment temperature Operation temperature range+20centigrade ~+30centigrade Store temperature range -40centigrade ~+70centigrade Environment humidity Operation humidity range: 30%~75% Store humidity range: ≤ 80% Atmospheric pressure range: 500hpa~1060hpa
Other specification
Noise level within hood environment ≤ 55dB(environment noise below 45dB carbon dioxide (CO2) level within the hood less than 0.5% when a mixture of CO2
In air is delivered at 750ml/min
At point 10cm above the center of the mattress. Air velocit y over mattress less than: 0.35m/s Infant bed max load: 10kg Transfusion shelf max load: 2kg Shelf max load: Cabinet max load: 6kg |