Our multifrequency remote control duplicator can be used for security systems, roller doors, shutters, sliding gates, barriers and household equipment. Frequency and code can be duplicated automatically. It can duplicate almost fixed code remote control in the market.

It is easy to operate without opening the enclosure and without external programmers.

You can store a code in each button even with difference frequency. For example you can store on buttons:

 

1.      FAAC 315MHz

2.      Multicode 310MHz

3.      Hormann 868.3MHz

4.      Marantec 433.92MHz

 

This is the only remote control in the market that permit to duplicate original remote control operating in following frequencies:

 

Technical  parameters:

1. Transmit Mode : ASK

2. The copy frequency error range: less than±200KHZ

3. Working voltage: 6V

4. Quiescent current: 0mA

5. Working current: 18mA

Operating instruction

 

  

 

To duplicate code:

1: Keep the original remote control near to remote control duplicator ( please note the range between them must be 2cm-7cm not less than 2cm, otherwise it will affect duplicate, you can adjust the copy distance by yourself according to your actual copy effect )

2:  Hold the original remote control button firstly (please note you need to do it firstly), then hold the remote control duplicator button (where you wish to duplicate the original remote control) until the LED flashes quickly, release both buttons and the code will have been accepted (please note if the original remote control is adjustable frequency, the duplicate time will be longer approximately 10 seconds, if the original remote controls have two waveband, it shows they can not be duplicated).  If the LED only flash once then go off during the duplicate process, it shows the system identification copy distortion then it will reset to duplicate automatically. Please do not release both buttons until the LED flash quickly at this moment.