DIY use all purpose wallcovering adhesive powder
Storing conditions:
Store in dry location, guarantee for 18 months-36 months.
Features & Benefits:
Product is characterized by high efficiency and joint strength
Easy mixing with cold water
Creates an anti-fungal environment
Adhesive does not harm environment
Product is approved by National Institute
Typical technical data
|
Type
|
Modified potato starch
|
|
Colour
|
White flake
|
|
Density
|
300-350kg / m3
|
|
pH
|
Approx 9
|
|
ViscosityⅠ**
|
15000 mPa.s -20000mPas
|
Ph measured in solution1:30
Viscosity detemined in solution 1:30. Mesaurement taken after 2 mins.
Base preparation
Surfaces should be clean, dry and free from dust and flaking paint. Old wallpaper and loose paint must be removed before applying new wallpaper. If surface is highly absorbative it should be sized by primer.
Application
Dilute enough powder into (tap) water using the chart below. Stir to achieve a smooth consistency. Leave mixed product for approximately 5 minutes. After that, stir it again and it is ready-to-use.
Apply the adhesive to the wallpaper, follow wallpaper’s instructions. Starting from the top, roll paper in place, taking care to roll out air bubbles. Immediately remove excess adhesive and any adhesive on pattern side with damp cloth.
After dissolving adhesive may be stored for 7 days in closed bucket. Stir very well before use when was stored more than 1 day.