S3100E 3-Channel MICROLITE DSM2 /DSMX Receiver with S.BUS Output Free Shipping

MICROLITE DSM2 /DSMX Receiver  

 

 

Receiver Specifications: 

1.Type: 3-Channel Full-Range DSM2 Receiver (1 S.BUS output )
2.Modulation: DSM2 /DSMX
3.Band: 2.4GHz Dimensions (L xWx H):29x16x7mm
4.Weight: 3g
5.Voltage Range: 3.6-10v 
6.Antenna Length Main RX: 29mm   

Key Features 
3channels 1channels S.BUS output (1S.BUS Output)
Preset failsafe system
Compatibility (Spectrum and JR DSM2 and DSMX): DX6I,DX7,DX8,DSX7,DSX9 DSX11,DSX12

Package including:Receiver *1 pcs, bind plug *1pcs

Binding Procedure 

1. Put the binding harness into connector location marked BIND. Next apply power to the receiver.                                                                                                                                      

2. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested).

Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.    

3. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED

of both satellite and main receiver will illuminate solid. All fail-safes should be programed correctly now.   

4. Remove binding harness from the BIND channel. Restart the receiver by cycling it power off and turn on. 

All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. 

Surfaces and throttle should return to your preset fail-safe positions.