MICROLITE DSM2/DSMX Receiver
410JST
Receiver Specifications:
1.Type: 4-Channel Full-Range DSM2 Receiver
2.Modulation: DSM2 /DSMX
3.Band: 2.4GHz Dimensions (L xWx H):29x16x7mm
4.Weight: 3g
5.Voltage Range: 3.6-10v
6.Antenna Length Main RX: 29mm
7.1.25Pitch JST servo connectors
Key Features
*4 channels
*Preset failsafe system
*Compatibility (Spectrum and JR DSM2 and DSMX): DX6I,DX7,DX8,DSX7,DSX9 DSX11
*1.25Pitch JST servo connectors
Package including: 4CH Receiver*1 pc, bind plug *1pc
Binding Procedure
1. Put the binding harness into connector location marked BIND. Next apply power to the receiver. LED of receiver should illuminate.
2. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested). Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.
3. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. All fail-safes should be programed correctly now.
4. Remove binding harness from the BIND channel. Restart the receiver by cycling it power off and turn on and connect battery to Bind Channel is recommended. All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. Surfaces and throttle should return to your preset fail-safe positions. |
|
|
|
