Steel bar mesh welding machine
Technical Parameters:
|
Control System
The control system adopts synchronous control technique. The welding time and separate welding are controlled by computer with PLC program. The input front-panel is touch screen. It is easy to operate.
|
|
Main Engine
1. There are 24 pieces of electrodes that are special-designed and are made of square column copper. They show little wear rate and can be used on multiple sides.
2. The hopper device can send cross wires one by one automatically.
|
|
Mesh Pulling Part
The mesh drawing system controlled by Panasonnic servo-motor() adopts elastic tension and opening positioning mesh, which improves the precision of mesh opening size.
|
|
Mesh Falling Part
The mesh falling system is controlled by step motor. Mesh falling car (optional)
|
|
Mesh Sending Part
The mesh sending system is controlled by computer. It simplifies the process that every tensile spring has to be changed when the wire diameter is different. You only need to change the pressure of welding point. Welding aperture can adjust randomly within range.
|
|
Transformer
This machine equips typical and efficient transformer, which has 8-gear, enlarging the welding range. Every two welding electrodes need a water cooling transformer.
|
|
Power Voltage
The machine welds wire by supporting temporary current, so it requires electricity. We can design the machine according to the power voltage in your country.
|
Technical Parameters:
|
Wire Diameter
|
5-12mm
|
Width of Mesh
|
2500mm
|
|
Longitude Wire Space
|
100-300mm
|
Cross Wire Space
|
50-300mm
|
|
Welding Electrodes
|
24 pcs
|
Welding Speed
|
30 times/min
|
|
Longitude Wire Feeding
|
Pre-straightened&pre-cut
|
Cross Wire Feeding
|
Pre-straightened&pre-cut
|
|
Rated Electrical Power
|
100kva*12pcs
(water cooling transformer)
|
Rated Voltage
|
3-phase,380V/220V/415V/440V 50Hz or 60Hz
|
|
Overall Size
|
14*3.2*2.3m
|
Weight
|
6.5T
|