Products installation

1.Clean the display case, then turn on switch on the bottom of Security alarm holder for mobile host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open the screw hole cover firstly)

2.Connect the charger of Security alarm holder for mobile with the alarm host, the other end into the power socket in preparation for a fixed monthly charge.

3.Tear off the 3 adhesive tape from the Anti-Theft Terminal product for display and paste exhibit's back fastened

4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the product

5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status

6.The installation is set up