The complete set of receiver and remote are used for the garage door sliding door gate

Biggest load current on relay:
12A 14VDC or 7A 120 VAC

PROGRAMMING:

Press the P1:

-1 time to program R1 in monostable mode
-2 times to program R2 in monostable mode
-3 times to program R1 in bistable mode
-4 times to program R2 in bistable mode
Hold down the key of the radio remote control that you
Would like to acquire until the ledl blinks.

ERASING:

There are two ways of erasing
1. Erasing a single code:
Press P2 for about two seconds(release the key); The LED
Will light up, press the key on the radio remote control
That you want to delete.
2. Erasing all codes acquired:
Press P2 until the LED turns on(about 8 seconds).

Remarks:

Red: Power Yellow: NA(Closed)
Black: Earth wire Blue: CM(Common)
Green: Antenna Gray: NF(Open)

Installs(Control Switch):

Link CM and NF separately to the two pins of the switch
Or the wired wall control