*Kit contents:

1. V V body: 1 pcs

2. vivi nova  clearomizer: 2 pcs

3.18650 battery: 2 pcs

4. Charger: 1 pcs

5. Gift box: 1 pcs

 

specification

 

 

Description:

 

4 buttons on the lava tube:

 

1. "+" button, on press you can increase the voltage from 3v-6v, when you reach 6.0 v it starts back at 6v

2. "-" button, on press you can decrease the voltage from 6v-3v, when you reach 3v it starts back at 6v

3. On/Off button, press 5 times to lock or turn on the device

4. The activation button (the big one), press it for 5 times when you inhale .

 

*Features:

New generation Chrome lavatube V2,CE4, CE6, DCT etc all kinds cartomizer can be used on it without adaptors

 

1. 510 connector, you can see the atomizer resistance from the display

2. By clicking buttons "+" or "-" ,you can get the working voltage as you like, the display will show you the exact voltage, the best on 3.7 to 4.0ohm

3. Regulated output which keeps the voltage the same with each puff - regardless of your remaining battery power. As the battery drains, the device will keep the voltage onsistent.

4. Amperage Limiting to 4.0 amps –The device can monitor and shut itself off if it detects any excessive over-current conditions.

5. Battery Monitoring/Over-Discharge Protection

The Device can monitor the battery voltage and automatically turn off when the battery is discharged. When the battery capacity is going to be used up, the display will alert. Also the 18650 battery in it could take out, very convenient

6. Vent hole on the bottom of the device for added safety

7. Short Circuit/Atomizer Protection

 

How to operate:
1. The power lock button: Press this for 5 seconds to turn on the device and again for 5 seconds to turn off the device. This will disable the main user power button. Once the device startup, click the fire button 5 times continuously, to check the inner battery voltage.
2. Decreasing the voltage (-button): Press this button to decrease the voltage by 0.1 volt increments in the digital display once the voltage display reaches 3.0 volt the display will cycle back to 6.0 volts.
3. Increasing the voltage (+button): Press this button to increase the voltage by 0.1 volt increments in the digital display once the voltage display reaches 6.0 volt the display will cycle back to 3.0 volts.
4. The user power button: Once button 1. As been enabled, you can use this button to power the fitted atomizer.
Integraty informations: