Features of Food Grade Silicone for Bra/ Pasties
1) the softness feels like human body
2) non-toxic and odorless
3) high tear-trength and tensil-strength
Food Grade Silicone for Bra/ Pasties operations
1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)
2. Enclose the product (the original model) with four plastic plates or wooden plates.
3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.
4. Pour the mixture with correct mixing ratio into the model frame.
After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .
Notice: As our E-series silicone is platinum cure silicone, which is very easy to cause cure inhibition , so pls do remember thoroughly clean the model and tool before operation. Besides, pls avoid the liquid E-series silicone contact or mix with the following material, otherwise the silicone won’t be cured :
1. Liquid condensation silicone (condensation silicone not completely cured or organictin compounds )
2. Sulphur, sulfide and sulfur rubber materials.
3. Amine compounds as well as contains the amine materials.
4. Pewter solder flux.
1) the softness feels like human body
2) non-toxic and odorless
3) high tear-trength and tensil-strength
Food Grade Silicone for Bra/ Pasties operations
1. Stir part A and part B with right mixing ratio evenly. And get the mixture for vacuum-pumping. (If there is no vacuumizer, you can just pour the mixture slowly from the corner so that less bubbles caused)
2. Enclose the product (the original model) with four plastic plates or wooden plates.
3. Clean your products and brush a layer of release agent(detergent or soap water) on your product.
4. Pour the mixture with correct mixing ratio into the model frame.
After about 2-4 hours, when the silicone cured, get out the original model, and there you get a finished addition cured silicone mold .
Notice: As our E-series silicone is platinum cure silicone, which is very easy to cause cure inhibition , so pls do remember thoroughly clean the model and tool before operation. Besides, pls avoid the liquid E-series silicone contact or mix with the following material, otherwise the silicone won’t be cured :
1. Liquid condensation silicone (condensation silicone not completely cured or organictin compounds )
2. Sulphur, sulfide and sulfur rubber materials.
3. Amine compounds as well as contains the amine materials.
4. Pewter solder flux.