Cemented carbide rods are mostly applied for drill bits, end mills, and reamers with sub-micron grain grade YG10X, for non-ferrous precision cutting and wood cutting with grade YG6X, and for fiberglass reinforced plastics, titanium alloys, hardened steel with ultra-fine grain grade YG8X, etc.
Our carbide rods have a good shock resistance and bending resistance in use.
If you have any special needs on carbide rods, please do not hesitate to call, fax, or e-mail us by below ways. Our team will answer all of your questions in time.
|
Grade
|
Typical Physical Properties
|
Performances & Application
|
||
|
Density (g/m3)
|
Bending Strength (N/mm2)
|
Hardness (HRA)
|
||
|
YG6X
|
14.8
|
2800
|
92
|
Applicable to machining composite material, such as al-mg alloy, plastic, "king of plastic", carbon fiber, and ferrous alloy. It is recommend use to produce micro drill, micro milling cutter, reamer, and drill bit for machining al-mg alloy.
|
|
YG10X
|
14.4
|
3000
|
91.5
|
Applicable to machining steel, cast iron, stainless steel, heat resistant steel, nickel base, and titanium alloy. It is recommend use as general tools material, such as twist drill bit, milling cutter, rotation file, tape, and gun drill.
|
|
YG12X
|
14.1
|
3200
|
91
|
Applicable to machining titanium alloy, heat-resistant steel, stainless steel, grey cast iron, glass fiber, and reinforced plastics. It is recommend use to produce milling cutters, reamer and ball-end mill.
|